We manufactured two stainless steel tanks for Mavitec. The tanks are made of 304 Stainless Steel and have a volume of 10m3. Serpentine has been added to provide heating of the flow zone.They have a motorized mixer for mixing the product to be stored. Moreover, they are used in fluid material storage and product preparation.
In addition to the our main products which are bushing and sleeve bearings, sink roll and its arms etc., we focus on occupational safety simulation equipment, as well. In a company, every new employee should aware the potential accidents, so they should be trained. With the frequently encountered accident simulation, the employee knows how to […]
Scrap in every Continuous Galvanizing Line is always a very critical issue and has the one of the highest cost in a line as well as raw material, zinc and energy. Scrap Management Report prepared by Focus Engineering Co. covers our scrap ratio improvement in detail and its numerical proofs. As summary, we managed to […]
Do you know that Focus Engineering Co. is not only manufacturer of Stellite6, Tribaloy T800 Bushing and Sleeve Bearings, but we also do improve galvanizing line existing processes? In our customer’s Continuous Galvanizing Line, Process Speed Rate (%) has been increased from 83% to 95% for the High Coating Product (>180gr/m2), in 2020. The Lean […]
The adhesion test machine is used to check whether the coated zinc on the strip surface meets customer expectations. Thanks to the adhesion test machine, the blasting test of high thickness and high yield strength strip is done with less time and less power.
In a continuous galvanizing line (CGL) Sink Roll, Stabilizing Roll, Correcting Roll are used to guide strip which has gained mechanical properties by annealing in galvanizing line furnaces, through the zinc pot. The strip surfaces are coated in the zinc pot. 1- Sink Roll directs the strip coming from furnace towards to cooling tower as […]
In a continuous galvanizing line (CGL), Sink Roll, Stabilizing Roll, Correcting Roll are used to guide strip in zinc pot.Bushes and Sleeve Bearing installed to the Motor and Operator side of Sink, Stabilizing and Correcting Rolls are important for the followings;•Maximum wearing resistance at high temperature,•Compensating angular misalignments, various forces,•Improving the process efficiency and quality […]
A working continuous galvanizing line consists of several spare parts that must be renewed or replaced periodically. We, Focus Engineering Co. , research, develop and produce following spare parts and supply them all over the World for our valued customers;1. Bushing and Sleeve Bearing,2. Sink Roll , Stab. Roll and their arms,3. Radiant Tubes in […]